Vistalight nightsticks

Justin Vincent said:

I recently bought a second hand (but not very old)
nightstick set. Knowing that a replacement globe (rated at
6V, 12W will cost me at least A$25 I headed to my local
hardware store & found one (rated at 12V, 20W) that fits
for $4.50.

My knowledge of physics (P = V squared / R) tells me that
using it with the a 6V battery it will run at 5W. (Other
higher wattages were also available!)

Is there any reason why this wouldn't be a suitable
alternative?

A 12V bulb operated at 6V will, in my experience, produce
far less than the light output obtained by using it at its
rated voltage, perhaps as little as one tenth of the
expected brilliance. It is not the case that the light
output scales with the power used.

Also, if the housing is designed to dissipate only the heat
from a 12W bulb, the 15W unit might produce enough to damage
it, though I think that's probably not enough of a boost to
be a matter for serious worries.

Quoted message said:

(Also, in the process of replacing the globe I discovered
that one of the contacts that the globe sits on is held in
place by a weak solder. This broke off, requiring the
switch to be removed & the contact resoldered. Not an
impossible repair, but not something that an average user
would want to do!!)

To use the units at 12 volts, build a 12V battery pack. You
may find that it is possible to replace the NiMH cells in
the existing pack with units half the length but of the
same per-cell voltage, and keep the physical form factor of
the current setup. You'll need a different charger in that
case, though.
--
Typoes are a feature, not a bug. Some gardening required to
reply via email. Surrealism is a pectinated ranzel.

Justin Vincent said:

I recently bought a second hand (but not very old)
nightstick set. Knowing that a replacement globe (rated at
6V, 12W will cost me at least A$25 I headed to my local
hardware store & found one (rated at 12V, 20W) that fits
for $4.50.

My knowledge of physics (P = V squared / R) tells me that
using it with the a 6V battery it will run at 5W. (Other
higher wattages were also available!)

Is there any reason why this wouldn't be a suitable
alternative?

Physics also says that the wavelengths of thermo radiation
increase as the temperature drops. When you run the bulb at
below the voltage it is designed for, the temperature of the
filament does not reach the point where it can produces
significant amount of VISIBLE light - efficiency goes down
drastically. Most of the radiation will be in infrared which
will not help you.

Justin Vincent said:

I recently bought a second hand (but not very old)
nightstick set. Knowing that a replacement globe (rated at
6V, 12W will cost me at least A$25 I headed to my local
hardware store & found one (rated at 12V, 20W) that fits
for $4.50.

My knowledge of physics (P = V squared / R) tells me that
using it with the a 6V battery it will run at 5W. (Other
higher wattages were also available!)

Is there any reason why this wouldn't be a suitable
alternative?

Yes. See the nomograph at
carleylamps.comtables.htmOpen ↗

With half the voltage, the lamp will draw .68 as much
current. P = v X a, so it should draw 4.08 watts (6v X .68
a)

However the light output will only be a tenth of the
designed output, and will be a very low (yellow/orange)
colour temperature.

The good news is that the bulb will last virtually forever
under these conditions.

Sheldon "Electrons" Brown +--------------------------------------------------------
---------+
| This message has been sent to you using recycled
| electrons | exclusively. Please do not discard them
| after use, | send them along and help conserve these
| irreplaceable | sub-atomic resources for future
| generations. |
+-----------------------------------------------------------
------+ I was on vacation, traveling in France and England
throughout most of the month of June.

Due to the SPAM and Virus problem, I typically get about
4,000 emails daily. Usually my filters are able to deal with
the flood, but while I was overseas, I wasn't able to get
Internet access as often as I would have liked.

As a result, my mailbox got choked up on two occasions,
causing the loss of about 190 mb of mail (tens of thousands
of messages) each time.

If you mailed me and didn't get an answer, please re-send
your message.

Harris Cyclery, West Newton, Massachusetts Phone 617-244-
9772 FAX 617-244-1041 harriscyclery.comharriscyclery.comOpen ↗ Hard-to-
find parts shipped Worldwide captainbike.comcaptainbike.comOpen ↗
sheldonbrown.comsheldonbrown.comOpen ↗

"G. Huang" <gang@removethis_bell-labs.com> wrote in message
"]news:[email hidden]...

Quoted message said:

Justin Vincent said:

I recently bought a second hand (but not very old)
nightstick set.

Knowing

Quoted message said:

Quoted message said:

that a replacement globe (rated at 6V, 12W will cost me
at least A$25 I headed to my local hardware store &
found one (rated at 12V, 20W) that

fits

Quoted message said:

Quoted message said:

for $4.50.

My knowledge of physics (P = V squared / R) tells me
that using it with

the

Quoted message said:

Quoted message said:

a 6V battery it will run at 5W. (Other higher wattages
were also

available!)

Quoted message said:

Quoted message said:

Is there any reason why this wouldn't be a suitable
alternative?

Physics also says that the wavelengths of thermo radiation
increase as the temperature drops. When you run the bulb
at below the voltage it is designed for, the temperature
of the filament does not reach the point where it can
produces significant amount of VISIBLE light - efficiency
goes down drastically. Most of the radiation will be in
infrared which will not help you.

Well, you can't argue with physics! I guess trying a
higher rated 12V 40W

globe still wouldn't be the same either.

Justin Vincent said:

I recently bought a second hand (but not very old)
nightstick set. Knowing that a replacement globe (rated at
6V, 12W will cost me at least A$25 I headed to my local
hardware store & found one (rated at 12V, 20W) that fits
for $4.50.

My knowledge of physics (P = V squared / R) tells me that
using it with the a 6V battery it will run at 5W. (Other
higher wattages were also available!)

Is there any reason why this wouldn't be a suitable
alternative?

It won't work at all. You need a six volt bulb.

Reflectalite has the six volt MR-11 bulbs for a bit less. I
didn't check shipping costs, though.

I've dealt with them on other items, and the service was
good.

reflectalite.comhalogenpage.htmlOpen ↗

--
Frank Krygowski [To reply, remove rodent and vegetable dot
com. Substitute cc dot ysu dot edu]

Justin Vincent said:

Well, you can't argue with physics! I guess trying a
higher rated 12V 40W globe still wouldn't be the
same either.

No. It would probably just generate enough heat to melt the
housing without providing enough illumination to see much.
Bulbs are not like diodes, SCRs, etc, where a higher-rated
unit can be pretty freely used as a replacement for a lower-
rated one. With bulbs, the voltage spec is critical.

--
Typoes are a feature, not a bug. Some gardening required to
reply via email. Surrealism is a pectinated ranzel.