Cycling Equipment · Public discussion

tires out of round

Started by Mike Bricker · · Last activity · 7 posts · 293 views

Thread navigation

Jump through the discussion

Go to the original post, the replies on this page, or the latest preserved contribution.

Thread details

What we know about this thread

Original section
Cycling Equipment
Published
25 August 2006
Last activity
26 August 2006
Original author
Mike Bricker
Posts
7
Discussion status
Public discussion
Total views
293
Views / 30 days
0

The navigation and discussion metadata provide context. Posts remain in their original chronological order.

Showing posts 1–7 of 7
Posts remain in their original chronological order.

Text size
  1. Anyone else having trouble with road tires out of round or flat spots on
    them. I use the best tires?? Mike

  2. Mike Bricker said:

    Anyone else having trouble with road tires out of round or flat spots on
    them. I use the best tires?? Mike

    Dear Mike,

    http://www.sciencenews.org/articles/20040403/mathtrek.asp

    Cheers,

    Carl Fogel

  3. "Mike Bricker" <[email hidden]> wrote in message
    news:[email hidden]...

    Quoted message said:

    Anyone else having trouble with road tires out of round or flat spots on
    them. I use the best tires?? Mike

    No.

    And what is the "best" tire? I have Vittoria's Continentals, Vredesteins
    and Michelins with no roundness issues.

    Sounds like you either routinely skid the rear (bad form), or do not
    properly center the tire when mounting. First ensure that the valve is
    pushed IN and the tire seated under it at that point before inflation. Put
    just a few psi in the tire and then work all the way around the rim pushing
    the bead free of the rim. Look into the gap as you go and ensure the tube
    is not trapped under the tire, and that the bead seats uniformly on the rim
    hook. Inflate. Ride roundness.

    Me

  4. rotate tires-tubes-and slime liner
    to a different rim orientation.
    also helps to bucket wash sidewalls with brush und dish detergent
    und wipe rim clean inside und out
    lube tube und sidewalls with HD silicone (CRC ?)
    butbutbut at end of road tire goes increasingly wobbley
    logwise sometimes spectak!

  5. Mike Bricker said:

    Anyone else having trouble with road tires out of round or flat spots on
    them.

    Depends on how flat the road is.

    -- mike elliott

  6. Mike Bricker said:

    Anyone else having trouble with road tires out of round or flat spots on
    them. I use the best tires?? Mike

    These days, it seems that even inexpensive tires (e.g., the $10,
    Chinese made Nashbar branded tires) run fairly straight.

    Is this happening on just one rim? If so, check to make sure the tire
    is seated properly. If it is, check to see if the problem is in the rim
    (remove the tire and spin the rim, checking for trueness, roundness and
    check to see if there is a noticeable wide or narrow spot between the
    bead seats).

  7. Mike Bricker said:

    Anyone else having trouble with road tires out of round or flat spots on
    them. I use the best tires?? Mike

    I got a bum IRC 26x1 3/8 from bikepartsusa a while back. It was put on
    an old German utility bike that my mother uses to ride down to the
    store. She commented that the rear went "thump thump thump" very
    gently, so I tried truing the wheel's roundness. Didn't catch it untill
    I finally gave the wheel a good spin and payed attention--it was 4mm
    out of round in one spot! No idea how you can screw up a tire like
    that.

    Other than that, they've all been round, and I've worn out a lot of
    tires, both moderately expensive, and proudly dirt cheap.

Active in the last 60 minutes

Active in this thread

0 users · 0 guests ·0 bots ·0 total

No signed-in users are active right now.

No known search crawlers active right now.