OK, so today I decided that I would finaly cut down my Velo (torker DX)
seat foam. I took off the bumper and handle and removed the seat
cover. I decided that a hacksaw would be best, because I wasnt allowed
to use my mom's serated bread knife and my pocket knife didnt work. I
cut it down to about 1" and after some messing around, I got the
seatcover back on, put the bumper and handle back on, put just a few
staples in it and some electrican tape to hold it down. I did a bunch
of searches before cutting and found out that I should keep the top
half to use. The only problem with that is that the sides have no foam
on the so the seat cover is pretty loose. There is a picture of me
squeezing (dont worry, thats not my SIF grip ) as much as I might when
doing SIF (maybe a bit harder that I would hold it) to show you how
loose it is. Also, its hard to tell from these pictures but there is a
bunch of space between the bumper and the seat, and the same for the
handle. Is that OK?
+-------------------------------------------------------------------+
|Filename: IMG_1593_1.JPG |
|Download: http://www.unicyclist.com/attachment/16057 |
+-------------------------------------------------------------------+
--
maximus unius
Quoted message said:
Originally Posted by *Brian MacKenzie*
Have you tried rubbing your nipples with grease before twisting them so
tightly?
------------------------------------------------------------------------
maximus unius's Profile: http://www.unicyclist.com/profile/13699
View this thread: http://www.unicyclist.com/thread/54642