chain tool design

Quoted message said:

THE ANSWER!

to chain tool pin control

the answer is-drill a small hole into the chain tool's surface below
and to the right of the pin's passage to the alleged target-the chain
pin surface.
insert [censored]!

That sounds rather uncomfortable to me, and (without boasting too much)
I don't think it would fit ;-)

Quoted message said:

THE ANSWER!

....

Quoted message said:

insert [censored]!

Makes one wonder what the question was!

Quoted message said:

in the Makes one wonder category -

take the parks chain tools and putem ina vice! then place lands on
either side to hold the chain up straight, 1x4 lands held off course by
two angle irons set into the vise.
or chop a slot into a 1x4" to fit the parks or...

maybe the force of an adjuster [censored] throws the entire design scheme of
balance? permanently and fatally damaging the side links cups?

one wonders?

Quoted message said:

Quoted message said:

in the Makes one wonder category -

take the parks chain tools and putem ina vice! then place lands on
either side to hold the chain up straight, 1x4 lands held off course by
two angle irons set into the vise.
or chop a slot into a 1x4" to fit the parks or...

maybe the force of an adjuster [censored] throws the entire design scheme of
balance? permanently and fatally damaging the side links cups?

one wonders?

W H A T ? ? ?

jeverett3<AT>earthlink<DOT>net http://home.earthlink.net/~jeverett3

i lay down last night listenbing to the sopund of hundreds of cyclists
turning their parks chain tool handles 90 degrees.
actually what i herd was two kids chiding me for "being" to picky! that
the tools is used simply by screwing the pin and against the pin,
yelling geronimo, and screwing rapidly pushing the chain pin out!

mustabeen dirtkids!

turd hand advised on this and i listened. then one day, exasperated! i
screwed the pin out (with my parks $11)not wildley but i didn't keep
the pin directly centered on pin whilst screwing
aahhhh!!
aaaahhhh sheeeeett!
that pin failed first.

then im allowed the chain to not lay perfectly straight across the
tools land proper!

and that pin bushing failed first.

chain tool mods increase chaining pleasure and reliability.

John Everett said:

Quoted message said:

Quoted message said:

in the Makes one wonder category -

take the parks chain tools and putem ina vice! then place lands on
either side to hold the chain up straight, 1x4 lands held off course by
two angle irons set into the vise.
or chop a slot into a 1x4" to fit the parks or...

maybe the force of an adjuster [censored] throws the entire design scheme of
balance? permanently and fatally damaging the side links cups?

one wonders?

W H A T ? ? ?

LOL! That's been my response to quite a few of dadakoll's posts. If English
speakers don't understand ...

Good technical writing can be quite challenging (I've done some), to say the
least, and there's great temptation to nix clarity and just ... spew.

All that said, I do applaud datakoll's putterings around, And his sharing of
ideas.

A. bicyclists tend to be stuffy
B. cyclists reading skills are below grade
C. humor is not characteristic common and obviuous amung cyclists
D. cyclists when asked to think often retreat to look at their...
E. when orville and wilbur died, inventive cycling moved to california.
F. Cyclists make poor musicians
G.
H.

Quoted message said:

A. bicyclists tend to be stuffy

We shan't stoop to address that.

Quoted message said:

B. cyclists reading skills are below grade

What do you mean?

Quoted message said:

C. humor is not characteristic common and obviuous amung cyclists

Well, that sentence (attempt) is pretty funny.

Quoted message said:

D. cyclists when asked to think often retreat to look at their...

Wee-wees?

Quoted message said:

E. when orville and wilbur died, inventive cycling moved to
california.

Nuts roll west.

F. Cyclists make poor musicians

Financially?

Quoted message said:

G.

Quoted message said:

H.

Got nuthin', eh? WE WIN!!! (Whoever the hell 'we' are.)

no, one would hope for a coherent witty urbane insightful creative
string of well organized thought on the subject-
chain tool design and mod!
this i would expect from the bros.