Bearing opening

Can't help you out but are those the delicous rice krispy treats you
have it sitting on?

--
tuna6869 - Unicycler for Kerry

Jamey Mossengren

Smile! 🙂 It makes people wonder what you're up to!

"Life is not measured by the number of breaths we take, but by the
moments that take our breath away"

------------------------------------------------------------------------
tuna6869's Profile: http://www.unicyclist.com/profile/1526
View this thread: http://www.unicyclist.com/thread/35493

tuna6869 said:

*Can't help you out but are those the delicous rice krispy treats you
have it sitting on? *

Yes it is.

sorry about the picture being blurry thats the best I can do with the
current camera.

--
Tim - Thread Killer

You not that evil Nick... I think that dog is more evil then you. - me

"The dog is my apprentice." - Evil-nick
------------------------------------------------------------------------
Tim's Profile: http://www.unicyclist.com/profile/4671
View this thread: http://www.unicyclist.com/thread/35493

The metal seals are difficult to remove without damaging the seal.
Every time I've tried to remove a metal seal I end up bending the metal
seal and otherwise damaging it so that it is impossible to reassemble
the bearing properly. Bearings with rubber (or plastic) seals are much
easier to disassemble and reassemble.

I use small screwdrivers, like the kind used to repair eye glasses, to
pry the seals off.

Brian MacKenzie (Sofa) used to have a FAQ on repairing bearings. The
link I have to that FAQ is now dead. Hey Brian, where's the FAQ at now?

--
john_childs - Guinness Mojo

john_childs (at) hotmail (dot) com
Gallery: '' (http://www.unicyclist.com/gallery/john_childs)
------------------------------------------------------------------------
john_childs's Profile: http://www.unicyclist.com/profile/449
View this thread: http://www.unicyclist.com/thread/35493

john_childs said:

*Brian MacKenzie (Sofa) used to have a FAQ on repairing bearings. The
link I have to that FAQ is now dead. Hey Brian, where's the FAQ at
now? *

I did a search and found that thread but couldnt get anywhere from it
because of the dead link.

I was trying to do it with out doing damage but couldn't get any where.
I guess there's no trick to it.

Thanks John

--
Tim - Thread Killer

You not that evil Nick... I think that dog is more evil then you. - me

"The dog is my apprentice." - Evil-nick
------------------------------------------------------------------------
Tim's Profile: http://www.unicyclist.com/profile/4671
View this thread: http://www.unicyclist.com/thread/35493

john_childs said:

*
Brian MacKenzie (Sofa) used to have a FAQ on repairing bearings. The
link I have to that FAQ is now dead. Hey Brian, where's the FAQ at
now? *

Whenever the instructions are found, they should be given to AC to put
on his site.

--
daino149 - On Vacation - till i find a job

Check out my pics: www.unicyclist.com/gallery/daino Updated: 04.07.03
Kaena
Bugman - "if you are a little left of them, it would seem like they are
on the right"
Sig count: 2

04.05.23 11214
04.05.25 11284
04.05.26 11329
------------------------------------------------------------------------
daino149's Profile: http://www.unicyclist.com/profile/933
View this thread: http://www.unicyclist.com/thread/35493