An inch behind KOPS: Anybody doing it?

In article said:

Just picked up a new custom hardtail frame and it looks like something went way wrong with the
frame tube/angle calculation.

Shouldn't that be the builder's problem to rectify?

Quoted message said:

The best I can get with the saddle all the way forward is my knee a good inch in back of the pedal
spindle.

I've ridden in front of KOPS - on a too-short frame. Main effect seemed to be to put my butt too
far back on the saddle as my bod found KOPS on it's own while riding.

But this is the first time I've had a too-long frame and been behind KOPS - seems like the
narrowing of the saddle as one moves forward would mitigate against my bod finding KOPS on
it's own.

The reason I'm trolling for someobody who rides behind KOPS is that I'd like to think this isn't
a total loss and I'm going to be able to ride it without the prospect of repetitive-use injury to
my knees.

Most Euro pro road racers ride with their knees well behind KOPS, from the looks of them in photos.
20,000 miles a year or more that way. Probably not a big deal, unless it makes your position
uncomfortable or adversely affects handling.

Personally, if the error was the frame builder's I wouldn't accept the frame. I'd return it. Would
you accept a suit from a tailor that didn't fit?

(Pete Cresswell) said:

Just picked up a new custom hardtail frame and it looks like something went way wrong with the
frame tube/angle calculation.

The best I can get with the saddle all the way forward is my knee a good inch in back of the
pedal spindle.

I've ridden in front of KOPS - on a too-short frame. Main effect seemed to be to put my butt too
far back on the saddle as my bod found KOPS on it's own while riding.

But this is the first time I've had a too-long frame and been behind KOPS - seems like the
narrowing of the saddle as one moves forward would mitigate against my bod finding KOPS on
it's own.

The reason I'm trolling for someobody who rides behind KOPS is that I'd like to think this isn't
a total loss and I'm going to be able to ride it without the prospect of repetitive-use injury to
my knees.

But I wouldn't want to find out the hard way....

FWIW, I tend to ride further back (relative to KOPS) on my MTB - I do more climbing and it helps me
get my glutes into the game. It does tend to make my front end a bit lighter though, and I have to
be careful not to wash out the front tire in sandy areas (and there are a LOT of those in Arizona).

BTW, are you measuring the KOPS while in your normal riding position? If not, you may find that the
shock will compress enough to move your knee considerably further forward (though I doubt an inch).

Mark Hickey Habanero Cycles habcycles.comhabcycles.comOpen ↗ Home of the $695 ti frame

"(Pete Cresswell)" <[email hidden]> wrote in message
news:<[email hidden]>... <snip>

Quoted message said:

The reason I'm trolling for someobody who rides behind KOPS is that I'd like to think this isn't
a total loss and I'm going to be able to ride it without the prospect of repetitive-use injury to
my knees.

But I wouldn't want to find out the hard way....

Comments?

I've ridden for 12 years and tens of thousands of miles with my knees well behind KOPS. My knees are
quite happy.

The rest of me is pretty happy, too- I ride recumbents. :-)

I'd say that you should adjust the seat in the middle of the rails; put on a tall, short reach stem;
and ride the heck out of the bike.

Jeff

Jeff

I'm only about 1cm behind KOPS and don't have any problems.

Did you do the measurement yourself? If so, have someone else try while you just sit on the bike.
I've noticed that when I'm fitting friends, that if they're looking at what I'm doing, it affects
the measurements.

Mike

"(Pete Cresswell)" <[email hidden]> wrote in message "]news:[email hidden]...

Quoted message said:

Just picked up a new custom hardtail frame and it looks like something

went way

Quoted message said:

wrong with the frame tube/angle calculation.

The best I can get with the saddle all the way forward is my knee a good

inch in

Quoted message said:

back of the pedal spindle.

I've ridden in front of KOPS - on a too-short frame. Main effect seemed

to be

Quoted message said:

to put my butt too far back on the saddle as my bod found KOPS on it's own

while

Quoted message said:

riding.

But this is the first time I've had a too-long frame and been behind

KOPS -

Quoted message said:

seems like the narrowing of the saddle as one moves forward would mitigate against my bod finding
KOPS on it's own.

The reason I'm trolling for someobody who rides behind KOPS is that I'd

like to

Quoted message said:

think this isn't a total loss and I'm going to be able to ride it without

the

Quoted message said:

prospect of repetitive-use injury to my knees.

But I wouldn't want to find out the hard way....

Comments?
-----------------------
Pete Cresswell

RE/

Quoted message said:

BTW, are you measuring the KOPS while in your normal riding position? If not, you may find that the
shock will compress enough to move your knee considerably further forward (though I doubt an inch).

I'm not sure. I'm measuring it the same way as on my 'real' bike, though: I get on the bike, put my
butt where the indents are on the saddle, set a crank parallel to the ground, and drop the plumb bob
with the line against my kneecap.

Right or wrong, the other bike seems to work - no knee problems and, to me at least, a comfortable
riding position - albiet a very light front end from the setback seatpost.

My knees definately tell me about it when I do 20-30 miles on my utility bike - on which the knees
are forward of KOPS.

OTOH, I just heard from somebody else that being behind KOPS doesn't seem to cause injury - in fact
this person seemed to think that a lot of professional road riders ride that way anyhow.

That being the case, I think I'll try to work with this thing for awhile and see if I can live with
it. KOPS isn't a matter of principle - I'm just looking for something that works.

Also, this bike is intended just as a "go anywhere" road bike and a travel bike (I got it with the
B&S couplings). If things don't work out, I may be throwing myself on you guy's mercy....which is
probably what I should have done in the first place...depending on a cost comparison between
re-making this one "right" and going titanium. The second time around on this end should have a 100%
chance of success given that we have a concrete reference point - so that part of the decision is
probably a wash.
-----------------------
Pete Cresswell

With 5 3/4 inches of seatpost extension to play with, I'm thinking a viable workaround (instead of
junking the frame) would be brazing together a faux seatpost/seat tube: something that sticks down
into the seat tube on the bottom side and presents an offset section of seat tube to stick the real
seatpost into on the top side. The real seatpost could be trimmed so it doesn't hit the top tube.

Dunno how much overlap is necessary when sticking one tube into another, but I'd guess the amount
isn't that much, is well known, relates to the diameter of the tubes in question, and is a lot less
than 5 3/4 inches.

Not real elegant, but seems like it would get the saddle up where my butt is without dropping a
bundle on another frame...
-----------------------
Pete Cresswell

I don't see mention of whether your seatpost has any setback. If it does, as most do, you might find
your answer there. There's quite a range of seatposts on the market, some with no setback and some
made for negative setback (intended for triathletes, mainly). Control Tech used to make reversible
ones which were quite common; you might find one of those lying about or maybe on ebay. From a
typical setback post to an inline post will get you close to an inch right there, and the tri or
reversible posts even more. Saddles also vary a fair amount in how much fore-aft range of adjustment
the rails allow. I'd go for either of the above before a mudge like you're talking about.

SB

"(Pete Cresswell)" <[email hidden]> wrote in message "]news:[email hidden]...

Quoted message said:

With 5 3/4 inches of seatpost extension to play with, I'm thinking a

viable

Quoted message said:

workaround (instead of junking the frame) would be brazing together a faux seatpost/seat tube:
something that sticks down into the seat tube on the

bottom

Quoted message said:

side and presents an offset section of seat tube to stick the real

seatpost into

Quoted message said:

on the top side. The real seatpost could be trimmed so it doesn't hit

the top

Quoted message said:

tube.

Dunno how much overlap is necessary when sticking one tube into another,

but I'd

Quoted message said:

guess the amount isn't that much, is well known, relates to the diameter

of the

Quoted message said:

tubes in question, and is a lot less than 5 3/4 inches.

Not real elegant, but seems like it would get the saddle up where my butt

is

Quoted message said:

without dropping a bundle on another frame...
-----------------------
Pete Cresswell

(Pete Cresswell) said:

OTOH, I just heard from somebody else that being behind KOPS doesn't seem to cause injury - in
fact this person seemed to think that a lot of professional road riders ride that way anyhow.

It can cause injury, but not where you may think. If you are not pushing "down" when you pedal your
butt will move forward and back on the seat making saddle sores much more likely on long rides.
Unfortuately, you may not know that you have a problem until part way through a long ride. Do
sequential long days in the saddle before a week long (or longer) ride.

Richard Kaiser

RE/

Quoted message said:

It can cause injury, but not where you may think. If you are not pushing "down" when you pedal your
butt will move forward and back on the seat

I'm already noticing that - lots of sliding back-and-forth. I'm also thinking that an unexpected big
bump in the "forth" position could ruin my whole day....
-----------------------
Pete Cresswell

In article said:

RE/

Quoted message said:

It can cause injury, but not where you may think. If you are not pushing "down" when you pedal
your butt will move forward and back on the seat

I'm already noticing that - lots of sliding back-and-forth. I'm also thinking that an unexpected
big bump in the "forth" position could ruin my whole day....

Have you lowered the saddle to compensate for it being farther back?

RE/

Quoted message said:

Have you lowered the saddle to compensate for it being farther back?

Never thought about that.

Sounds like when I do the knee straight, heel on pedal thing, the pedal needs to be cocked a little
forwards of straight down.
-----------------------
Pete Cresswell

Pete Cresswell said:

With 5 3/4 inches of seatpost extension to play with, I'm thinking a viable workaround (instead
of junking the frame) would be brazing together a faux seatpost/seat tube: something that sticks
down into the seat tube on the bottom side and presents an offset section of seat tube to stick
the real seatpost into on the top side. The real seatpost could be trimmed so it doesn't hit the
top tube.

Dunno how much overlap is necessary when sticking one tube into another, but I'd guess the amount
isn't that much, is well known, relates to the diameter of the tubes in question, and is a lot
less than 5 3/4 inches.

Not real elegant, but seems like it would get the saddle up where my butt is without dropping a
bundle on another frame...

The Profile Fast Forward seatpost might also be an alternative or perhaps the Look ErgoPost.

RE/

Quoted message said:

From a typical setback post to an inline post will get you close to an inch right there, and
the tri or reversible posts even more. Saddles also vary a fair amount in how much fore-aft
range of adjustment the rails allow. I'd go for either of the above before a mudge like you're
talking about.

I'm wedded to the Brooks B-17.

As far as seatposts go, the ThudBuster I want to use on this bike (it's a hardtail) looks to have
about a half-inch inherant setback in it. But that's non-negotiable: my tender tush just doesn't
thrive on solid-rail saddles.

I *could* go to the four-wire Brooks B-72, and have done so in the past - but that's only going to
pick up that half inch.

Considering that when I config this thing for my Rohloff hub and tension the chain via the eccentric
BB we're going to add another half-to-three-quarters inch I think I'm looking at wanting about two
inches of forward shift (given that may be a little too much, but now the saddle is all the way
forward on it's rails - so there'll be some room for adjustment there...
-----------------------
Pete Cresswell

RE/

Quoted message said:

The Profile Fast Forward seatpost might also be an alternative or perhaps the Look ErgoPost.

That's the idea - but I want a sus post - specifically the ThudBuster.

-----------------------
Pete Cresswell

Read this

sheldonbrown.comkops.htmlOpen ↗

everybody is slightly different. What is good for one person might injure another.

Personally i ride way behind the bottom bracket. I don't know how far behind my knee is.....and I
don't care.....i just make sure the saddle is in the right place and that sets everything else up

Peter