Action Bikes & Halfords, Edgware

Don't blame Halfords for mis-selling the wrong freehub, blame Trek for being too scabby to spec
either fully shimano compatible freehubs (and therefore have to pay a small fee to Shimano), use
Shimano hubs anyway.

Over the years I've seen a number of hubs with the hub/freehub body interface reversed as opposed to
Shimanos version. Shimano have the male section on the hub body and the female section on the
freehub itself.

Al Ford said:

Don't blame Halfords for mis-selling the wrong freehub, blame Trek for being too scabby to spec
either fully shimano compatible freehubs (and therefore have to pay a small fee to Shimano), use
Shimano hubs anyway.

Over the years I've seen a number of hubs with the hub/freehub body interface reversed as opposed
to Shimanos version. Shimano have the male section on the hub body and the female section on the
freehub itself.

ALL Shimano's?

1. I don't know what model the hub is, but it is marked "Hyperglide". As this is a Shimano trade
mark, I assumed it was a Shimano hub. Or could it still be another brand?

2. Are Deore 8/9sp freehubs compatible with ALL Shimano 8/9sp hubs?

Anyway, thanks very much for the reply. From what you say, plus the fact that the hub isn't marked
with a Shimano logo or model numer, I guess the hub isn't Shimano after all. But I still would have
expected Halfords to have realised this or found it out (the whole wheel was brought to them). The
major part of the complaint, though, was about Action Bikes - who had NO excuses.

~PB

Quoted message said:

Anyway, thanks very much for the reply. From what you say, plus the fact that the hub isn't marked
with a Shimano logo or model numer, I guess the hub isn't Shimano after all. But I still would
have expected Halfords to have realised this or found it out (the whole wheel was brought to
them). The major part of the complaint, though, was about Action Bikes - who had NO excuses.

~PB

The main problem is that until you actually take the thing apart it is difficult to tell what
interface is used.

Al Ford said:

Quoted message said:

Anyway, thanks very much for the reply. From what you say, plus the fact that the hub isn't
marked with a Shimano logo or model numer, I guess the hub isn't Shimano after all. But I still
would have expected Halfords to have realised this or found it out (the whole wheel was brought
to them). The major part of the complaint, though, was about Action Bikes - who had NO excuses.

Quoted message said:

The main problem is that until you actually take the thing apart it is difficult to tell what
interface is used.

In that case, they should have either been willing and able to take off the freehub there and then,
or explain that they couldn't be sure what model would be suitable. Instead, they dithered about
then sold the wrong part with the assurance that it would fit.

I'm still not clear whether ALL modern 8sp MTB Shimano rear hubs are marked "Shimano" on the outside
somewhere. Can anyone answer this please? And I'd still like to know if modern Deore 8/9sp freehub
bodies fit ALL modern Shimano 8/9sp hubs.

~PB

Pete Biggs said:

In that case, they should have either been willing and able to take off the freehub there and
then, or explain that they couldn't be sure what model would be suitable. Instead, they dithered
about then sold the wrong part with the assurance that it would fit.

I'm still not clear whether ALL modern 8sp MTB Shimano rear hubs are marked "Shimano" on the
outside somewhere. Can anyone answer this please? And I'd still like to know if modern Deore 8/9sp
freehub bodies fit ALL modern Shimano 8/9sp hubs.

I'm still not sure why you bought the freehub in one shop and had it fitted in another. If it was
because it was cheaper its a false economy. Far better to have had one shop replace the freehub for
you from their stock. Probably would have charged you less for the fitting and if it did go wrong
you would have a far better case. As it is they will probably absolve themselves by saying you asked
them to fit an incompatible part

Tony

--
raven-family.comraven-family.comOpen ↗

"The reasonable man adapts himself to the world; the unreasonable man persists in trying to
adapt the world to himself. Therefore, all progress depends on the unreasonable man." -- George
Bernard Shaw

Pete Biggs said:

My brother has just told me of a bad experience today involving these two shops in the Edgware
area in north London.........

Quoted message said:

Freehub failed (sounded broken and couldn't freewheel at all), so he first went to Halfords to get
a replacement body, taking the whole wheel. The wheel was from a mid-price basic Trek 820 mountain
bike with low-end Shimano 8-speed components. Shop sold him a Deore freehub, assuring him that it
would be compatible.

Compatible with an 8 speed cassette, almost certainly. With other Shimano hubs, most likely. For
exceptions, see: sheldonbrown.comk7.htmlOpen ↗ For anyone elses hubs, see under
"cat in hell's chance". Trek wouldn't give a monkeys about Shimano compatibility in an area of a
cheap/midrange bike of theirs if you couldn't see it from a casual examination of the bike. When
manufacturers say things like "Shimano equipped", the phrase never seems to mean "equipped with a
full complement of shimano components", unless on expensive bikes.

However, Shimano parts pricing can tend to mean its not much more expensive to buy a complete hub
(especially online), but is obviously more difficult to swap the hub out.

Quoted message said:

The staff weren't ready and confident about fitting the part there and then so my brother just
took the part to get it fitted eleswhere. The freehub body turned out to be totally incompatible.

Doh!

Quoted message said:

That's bad enough but the story gets much worse.......

<snipped disaterous stuff about Action Bikes etc.>

Quoted message said:

BTW, would have been tricky to order online as the part or hub wasn't properly marked so we didn't
know what model was required as we aren't very familar with these kind of freehubs (but I would
expect Halfords to be!). Obviously, I wished I had helped directly more myself, but I live some
miles away and didn't know about it all until after the event.

It wasn't a shimano hub then. You don't say what year of Trek 820 the bike is, but the current 820
spec just says "alloy hubs" - almost certainly not Shimano, as "Shimano equipped" seems to be a
regularly used bit of advertising blurb, and you rarely see any Shimano hubs without Shimano logos.
I don't think Halfords sell Trek, and I would doubt even every Trek seller would have the right
spare freehub for that wheel. Also, bear in mind that the magic words in Halfords are "can I talk to
the bike specialist", who would be the member of staff most knowlegable about this sort of thing. He
or she would also have days off.

JimP

Tony Raven said:

Pete Biggs said:

In that case, they should have either been willing and able to take off the freehub there and
then, or explain that they couldn't be sure what model would be suitable. Instead, they dithered
about then sold the wrong part with the assurance that it would fit.

I'm still not clear whether ALL modern 8sp MTB Shimano rear hubs are marked "Shimano" on the
outside somewhere. Can anyone answer this please? And I'd still like to know if modern Deore
8/9sp freehub bodies fit ALL modern Shimano 8/9sp hubs.

I'm still not sure why you bought the freehub in one shop and had it fitted in another.

That's besides the point, and it was my brother and not me. He did ask for it to be fitted but did
not get a straight answer about when it could be done and also wanted it fitted on the same day if
possible. Halfords did not give the impression of being competent or organised so he went elsewhere.
Personally, I don't think I would have then accepted the part. (Actually, I wouldn't have gone to
Halfords or AB at all for this job but my brother is not quite so clued-up on modern bike equipment
or shops as I am; although I'm not cexactly lued-up mountain bike freehubs either).

So don't blame the customer!!!! The staff at Halfords didn't do their job properly. The customer did
not ask specifically for a Deore or even a Shimano freehub. The customer presented the whole wheel
and asked them to either replace the freehub or provide a _suitable_ freehub for it. In this
situation, under the Sale of Goods Act, the shop has a clear legal obligation (as well as a moral
one) to either do and supply nothing or fit/supply the correct goods.

Quoted message said:

If it was because it was cheaper its a false economy.

Was nothing to do with the cost.

Quoted message said:

Far better to have had one shop replace the freehub for you from their stock.

Of course. But if short of time and one shop seems to offer what's needed, there's the natural
inclination to grab it while you can because other shops may well not have it in their stock. ...You
know what bike shops are like! ...Lucky if they have what you want half the time.

Quoted message said:

Probably would have charged you less for the fitting and if it did go wrong you would have a far
better case. As it is they will probably absolve themselves by saying you asked them to fit an
incompatible part

I don't think you have fully understood the situation. Nevermind, there's bound to be no further
problem with Halfords as I'm sure they will take back the part for a full refund. It was Action
Bikes who bollocksed up big time (on the fitting).

~PB

Jim Price said:

Quoted message said:

The staff weren't ready and confident about fitting the part there and then so my brother just
took the part to get it fitted eleswhere. The freehub body turned out to be totally incompatible.

Doh!

Indeed, but men in a hurry do desparate things! As I've explained in my last message, Halfords still
were in the wrong. If they weren't sure, they should not have said that the part would be suitable,
and it now seems that the part was extremely unlikely to be suitabable!! The point was that Halfords
were [censored], but I suppose I'm preaching to the converted here! :-)

~PB

Thus spake "Pete Biggs" <[email hidden]>

Quoted message said:

Anyway, thanks very much for the reply. From what you say, plus the fact that the hub isn't marked
with a Shimano logo or model numer, I guess the hub isn't Shimano after all. But I still would
have expected Halfords to have realised this or found it out (the whole wheel was brought to
them). The major part of the complaint, though, was about Action Bikes - who had NO excuses.

I've not been inside Action Bikes, Edgware since I told the chap who ran the shop I had five bikes.

He said he only sold bikes and didn't ride them.

Enough said.

I now have one bike and *can't* ride it :-(

--
Helen D. Vecht: [email hidden] Edgware.

Helen Deborah Vecht said:

Quoted message said:

The major part of the complaint, though, was about Action Bikes - who had NO excuses.

I've not been inside Action Bikes, Edgware since I told the chap who ran the shop I had
five bikes.

...Five bike _shops_, I think you might mean - which is what my brother heard yesterday. I think the
bloke was boasting about it!

Quoted message said:

He said he only sold bikes and didn't ride them.

Enough said.

Indeed, it's enough to make the blood boil!

Quoted message said:

I now have one bike and *can't* ride it :-(

I'm sorry to hear that. I didn't realise (until very recently from another post of yours) that you
couldn't cycle at all now. I hope I'd still be interested in the world of cycling if I ever have to
give up riding myself.

Good luck.

~PB

Pete Biggs said:

Helen Deborah Vecht said:

Quoted message said:

The major part of the complaint, though, was about Action Bikes - who had NO excuses.

I've not been inside Action Bikes, Edgware since I told the chap who ran the shop I had
five bikes.

...Five bike _shops_, I think you might mean - which is what my brother heard yesterday. I think
the bloke was boasting about it!

Sorry, BRAIN FAILURE (I think I've got some kind of dyslexia!). From re-reading, I see _you_
had five bikes. By coincidence over the number "five", the manager there does indeed run five
bike shops.

~PB

Pete Biggs said:

Jim Price said:

Quoted message said:

The staff weren't ready and confident about fitting the part there and then so my brother just
took the part to get it fitted eleswhere. The freehub body turned out to be totally incompatible.

Doh!

Indeed, but men in a hurry do desparate things! As I've explained in my last message, Halfords
still were in the wrong. If they weren't sure, they should not have said that the part would be
suitable, and it now seems that the part was extremely unlikely to be suitabable!! The point was
that Halfords were [censored], but I suppose I'm preaching to the converted here! :-)

Well, not quite. I may end up working in Halfords in the next few weeks, due to the current state of
the UK IT jobs market. Maybe I can change peoples opinion of at least one Halfords store (a case of
men without a job do desperate things) - mind you, where I live, the local bike shops between here
and Halfords struggle to give them any serious competition on anything but who can sell the cheapest
bike. This may well be a good part of the reason why I've had to learn to do all of the servicing on
all of my bikes.

JimP

"Pete Biggs" <[email hidden]> wrote in message
news:<[email hidden]>...

Quoted message said:

Staff were also overheard giving bad advice to other customers about a simple problem with
some brakes.

There should be a law ...

--
Dave...

UPDATE #1: My brother has now been to a (proper!) shop and it's now obvious that the hub is NOT
Shimano and is "unusual". I suspect Trek changed the spec to save a few pennies - or maybe even the
dealer supplied non-Trek wheels. The shop is going to try to order a suitable freehub.

~PB