I must confess that I thought you could only get short or long cage rear derailleurs. Is there such a thing as a Medium Cage? If so will it work with a triple chain ring with a 11/23 cassette? Would a long cage be a better bet?
I must confess that I thought you could only get short or long cage rear derailleurs. Is there such a thing as a Medium Cage? If so will it work with a triple chain ring with a 11/23 cassette? Would a long cage be a better bet?
Many thanks in advance
I have never seen Medium Cage Ultegra advertised. Long cage would be a better bet IMHO. I have used a 105 short cage mech with a 13-24 cassette and 52/39/30 rings, and make sure I reserve the 30 for use with the two or three largest sprockets only
bluenose-<< must confess that I thought you could only get short or long cage rear derailleurs. Is there such a thing as a Medium Cage? If so will it work with a triple chain ring with a 11/23 cassette? >><BR><BR>
long or short for ultegra. Ideally, use the long one for your setup.
Peter Chisholm Vecchio's Bicicletteria 1833 Pearl St. Boulder, CO, 80302 (303)440-3535 vecchios.comvecchios.comOpen ↗ "Ruote convenzionali costruite eccezionalmente bene"
I must confess that I thought you could only get short or long cage rear derailleurs. Is there such a thing as a Medium Cage? If so will it work
I believe there's only a short and medium cage -- that is, they call the road-series derailers with larger cages "medium".
Quoted message said:
with a triple chain ring with a 11/23 cassette? Would a long cage be a better bet?
I'm using a 105 short cage with a 11/27 cassette and 30-42- 52 crank. Chain length is critical to making this work. That said, it works fine for me.
It does wind up a lot if I cross the 30 with small cogs, but works okay even then, and that's something I'd avoid either way. I'd say I have probably five cogs that I can use in the 30 ring without the chain rubbing the wrong end of the cage (maybe only four). The chain never goes slack or does anything terrible even in small-small.
The cage ends up nearly parallel to the ground if I cross big-big -- again, works fine, but not a good idea regardless of derailer cage. -- Rick Onanian
On Tue, 27 Apr 2004 04:34:34 GMT, Bluenose <[email hidden]>
Quoted message said:
Hi,
I must confess that I thought you could only get short or long cage rear derailleurs. Is there such a thing as a Medium Cage?
'Medium' has become a label due to mountain bike derailleurs. Shimano has SS (short) and GS (long/'medium'😉 in road models, and GS (short/'medium'😉 and SGS (long) in mountain models.
Quoted message said:
If so will it work with a triple chain ring with a 11/23 cassette? Would a long cage be a better bet?
A road medium (GS) is best. I've tried an SGS Deore (long) on a 12-25 and thought that the sifting was a bit off (and others here have reported no problems- go figure 🙂 I think this is because the geometry of the body is designed to work with up to a 34 tooth rear. I did adjust the angle in back as close as possible, but when I switched to a GS 105, the shifting improved markedly.