Phil I have made several of these bearing holders.
Ok.... i am seeing your idea... those things are BEEEEEFFY
So do you make them just so the bearings fit tight? or do you leave a small lip so the don't slide out?
zfreak220 said:
just buy two sets (four holders in total) of any of the following:
I would really like to avoid spending extra money... that and those are all to thin... i need something a little thinker... maybe not as thick as dangerdogs but still.....
-- Phil_on_uni
Quoted message said:
<> UNICYCLE FOR HATRED, BIGOTRY, AND IGNORANCE <><
the nimbus machined ones are pretty thick, at least 3-4mm. I would measure for sure but it's about 1 am right now and I don't think my parents would be too happy about me going into the garage. the only thing is you can't use the bolts that UDC uses for those ones, because to use them the top bearing holder has to be threaded.
the nimbus machined ones are pretty thick, at least 3-4mm. I would measure for sure but it's about 1 am right now and I don't think my parents would be too happy about me going into the garage. the only thing is you can't use the bolts that UDC uses for those ones, because to use them the top bearing holder has to be threaded.
thats not a problem... i can thread stuff. guess we will have to seee.......
-- Phil_on_uni
Quoted message said:
<> UNICYCLE FOR HATRED, BIGOTRY, AND IGNORANCE <><
Ok.... i am seeing your idea... those things are BEEEEEFFY
So do you make them just so the bearings fit tight? or do you leave a small lip so the don't slide out?
I would really like to avoid spending extra money... that and those are all to thin... i need something a little thinker... maybe not as thick as dangerdogs but still.....
I use little screws on the side to stop them sliding sideways.It would be almost impossible to make a lip if your using a grinder or file.
