I just started using my 710 with intervals on my bike on the trainer. My interval is "manual warm up" then "1min @100% effort" followed by "2min recovery" X 6. that = 1 set. My problem is that the HRM would stop and beep during the 1 min countdown. the red button would have a "start" above it and i'd press that, it would continue to countdown for another few seconds (no rhyme or reson for the time period) and then stop/beep and not countdown again until i pressed the red button. This continued until i was so fed up i stopped my interval. did this with both the recovery and the effort periods. Its likely obvious but any help would be great.
also Point #2. The above interval set had 3 repeats with a 5 min rest section in between each "set". Polar has no ability that i can find to schedule that 5 min rest then return to set #2. is this a problem with anyone else? My Interval should look like "warmup (manual)", Set 1 "1 min on, 2 min off" x6 5min recovery Set 2 "1 min on, 2 min off" x6 5min recovery Set 3 "1 min on, 2 min off" x6 5min recovery Cooldown (manual)
I just started using my 710 with intervals on my bike on the trainer. My interval is "manual warm up" then "1min @100% effort" followed by "2min recovery" X 6. that = 1 set. My problem is that the HRM would stop and beep during the 1 min countdown. the red button would have a "start" above it and i'd press that, it would continue to countdown for another few seconds (no rhyme or reson for the time period) and then stop/beep and not countdown again until i pressed the red button. This continued until i was so fed up i stopped my interval. did this with both the recovery and the effort periods. Its likely obvious but any help would be great.
Go to options - bike - autostart; make sure it's set to on. Should solve your problem. Otherwise, check to see if the speed sensor has been bumped out of position.
