Ok today I was killin time and wondered me way into a hardware store. And I've posted a few times about an outer seatpost on my uni just because I hate low trials seatclamps for flatland. So anyways I had my seat with me and my travel along pocket repair kit and found some tubing I could use to make a seatpost that will slide over the neck and clam at the bottom. I'm gonna take an old 4 hole bracket and mount it to the metal tubing then cut me a slit in the botom and the clamp will be down near the fork. Any suggestions on this? Is it even a very worthwhile Idea?
-- bcwheelriderguyhehehehehe
dudewithasock said:
Yeah, and they have more estrogen than me, too. Now *that* takes guts.
iridemymuni said:
hey evan i've got the same blue nipples as you !!!!!
tobbogonist said:
this may be off topic, but my trouser snake is called: Conan: The Barbarian
Ductape smells nice🙂 But what do ya mean it would be hard to get the clamp down far enough? I got a real fat one taht will fit over and itle be like a normle seat clam just farther down the neck.
-- bcwheelriderguyhehehehehe
dudewithasock said:
Yeah, and they have more estrogen than me, too. Now *that* takes guts.
iridemymuni said:
hey evan i've got the same blue nipples as you !!!!!
tobbogonist said:
this may be off topic, but my trouser snake is called: Conan: The Barbarian
AND what would you do if you ned to raise the seat? You would have to move the clamp up with it.
Make it a cut to fit. Unless you are adjusting the height of your post all the time, you'll only need it one length. If this was something to be massed produced, then that would be something to think about. I deffinately think it would work. Would you be able squeeze a 27.2 post over a25.4???
