Fraggle said:Thanks for your Comments guys. I replaced the Battery and am now getting data through to the watch. Must have been a faulty battery.
Now on a side note. Display setting on the Watch for power output !
Have any of the users out there been able to set up the display as:
L/R Balance
Power output
Heart Rate (Altitude)
If so where abouts in the settings can this be done ?
Cheers
Fraggle
There is an option for that though I'm not sure what you mean by
"Heart Rate (Altitude)"
BTW I'm assuming this is a S725.
When you start your recording the watch should start with the stop watch time in the middle Speed up the top and %HR down the bottom.
Whilst recording the Bottom right buttom will cycle through the middle section option. The top options will change as well to the default settings as you cycle through them.
Four push's will get you to Power. (can't remember all of them tho Altitude is NO# 3) Then use the Top left to cycle through to LR balance.
By pusing and holding the bottom right you can change the way your HR reads. Average, normal HR and % of max.
IMHO though the LR balance is not very good too look at while you are training because the readings will not make any sense. Basically it will read stuff like 75-25, 82-18 etc etc. However once you get back and look at the stats they will be averaged into more meaningful data. For example mine normally ends up 51-49. However I don't think I have ever seen that or anything close to it while riding. The reason for this is due to the fact you are smpling at best every 5 sec. You definitly will not get anything like a power curve for each leg. If you want that you will need SRM's with the additional S/W.
