Tony Sweeney said:This question was asked in the recent thread about how many km people
got from their tyres but went unanswered.
Is there a way to repair a large cut in a tyre?
The kind of cut that you can see a small amount of tube through when
fully inflated because the casing has been cut through significantly
enough. And which I seem to consistently puncture in the same spot as a
consequence (which would make perfect sense!).
That's probably not a puncture... I'd bet it's a blowout.
Quoted message said:(The question goes for the main, contact portion of the tyre and the
sidewall.)
I have used a section of old, worn tyre with the bead cut off as a tyre
boot to get me home after such a puncture. Is that the best/only
permanent repair? Are there any disadvantages to riding around with a
tyre boot like this?
For sidewall cuts of that type, I use a folded wrapper from a snack bar
betwixt tyre and tube. I've tried the old tyre with the removed bead --
the cut edge of the old tyre rubbed the tube and eventually caused a flat.
I have a folded wrapper in the front tyre of my commuter bike right now,
and it's been there for several hundred miles. The tyre bulges ever so
slightly at that point, and you can see the wrapper from the outside,
but it is not noticeable when riding.
I don't know if this works in the tread portion of a tyre, and it might
not work with all combinations of tyre, cut, and wrapper. A good rule of
thumb: if you can boot a sidewall cut without leaving a significant
bulge, it will probably continue to work indefinitely.
As usual, usenet advice is worth the price you paid. Don't blame me if
your booted tyre fails. :^)
--
Dave
dvt at psu dot edu
Everyone confesses that exertion which brings out all the powers of body
and mind is the best thing for us; but most people do all they can to
get rid of it, and as a general rule nobody does much more than
circumstances drive them to do. -Harriet Beecher Stowe, abolitionist and
novelist (1811-1896)