Road Cycling · Public discussion

Touch Up Paint

Started by Dave Ortman · · Last activity · 5 posts · 429 views

This thread is locked and is currently read-only.

Thread details

What we know about this thread

Original section
Road Cycling
Published
25 July 2004
Last activity
26 July 2004
Original author
Dave Ortman
Posts
5
Discussion status
Public discussion
Total views
429
Views / 30 days
0

The navigation and discussion metadata provide context. Posts remain in their original chronological order.

Showing posts 1–5 of 5
Posts remain in their original chronological order.

Text size
  1. Whoops. I have my first ding. Given how often I put my bike into my trunk
    and take it back out, I assume it was just a matter of time.

    This morning I was putting it in the trunk when I must have let the
    handlebars swing inward too far. The bottom of my handlebar met my frame,
    and it tore the sticker a bit and dinged the paint underneath. The ding is
    on the bottom side of the top tube, so I'm not worried about touching it up.
    I just wanted to fix it so that the sticker doesn't continued to peel off
    (it's a Trek 2200; and sticker I damaged is fairly large).

    I was assuming that clear nail polish might be the best choice just to seal
    things up so that the paint and/or sticker do not peel away further. Before
    I tried that though, I figured I would check to see if there were better
    options.

    Thanks,
    -Dave

  2. Dave Ortman said:

    I was assuming that clear nail polish might be the best choice just to
    seal things up so that the paint and/or sticker do not peel away further.
    Before I tried that though, I figured I would check to see if there were
    better options.

    You're on the right track--just don't let your wife catch you...

    😄

  3. "Dave Ortman" wrote: (clip) I was assuming that clear nail polish might be
    the best (clip)
    ^^^^^^^^^^^^^^
    Clear nail polish might work OK, but, since it is a lacquer, there is a
    possibility it will damage either the finish or the label. I suggest you
    cut a strip of clear "Contact*," and wrap it over the label and around the
    tube. It will hold the corners down, give you an extra layer if protection,
    and should hardly show if done carefully.

    *The adhesive backed plastic that comes in rolls--commonly used as a shelf
    liner. The clear is wonderful for laminating documents, repairing maps,
    etc.

  4. ou said it. Clea nail polish.

    - -

    "May you have the wind at your back.
    And a really low gear for the hills!"

    Chris Zacho ~ "Your Friendly Neighborhood Wheelman"

    Chris'Z Corner
    http://www.geocities.com/czcorner

  5. "Leo Lichtman" <[email hidden]> wrote in message news:<[email hidden]>...

    Quoted message said:

    I suggest you
    cut a strip of clear "Contact*," and wrap it over the label and around the
    tube. It will hold the corners down, give you an extra layer if protection,
    and should hardly show if done carefully.

    *The adhesive backed plastic that comes in rolls--commonly used as a shelf
    liner. The clear is wonderful for laminating documents, repairing maps,
    etc.

    Ah, that's a fine suggestion - much better than the passing thought I
    had to use clear packing tape. I assume that it would adherd to the
    frame in a much more permanent manner than the tape would.

    Thanks,
    -Dave

Active in the last 60 minutes

Active in this thread

0 users · 0 guests ·0 bots ·0 total

No signed-in users are active right now.

No known search crawlers active right now.