!Jones said:When setting up a double cable lever (Mafac) on a tandem with a hub
brake, does one usually set up the cantilevers on the double and the
hub on the single pull?
I think that's the common setup, yes.
Quoted message said:I can see an advantage to that; however, I like to have the wheels
brake independently, also. Generally, I put the drag brake on the
stoker's bars, but with such a neat lever, I'd like to use it.
That's what I've always done (hub brake under stoker control), so what
follows is memory from the words of those who've tried it, and
speculation (Hey! This is R.B.T.!) Note: here I am using "hub brake"
as interchangeable with "disk brake;" granted this may not be common usage.
Quoted message said:Can it be set up successfully running the rear cantilever and the drag
brake on one lever? ... in your opinion, of course. Most anything
*can* be done; however, some things are better candidates than others.
I'm thinking about setting the drag to hit first with an in-line
spring.
I think you've identified the main problem here - one type of brake has
more travel than the other to reach a certain level of tension/braking.
IIRC, the word was that this was a tricky thing to get right. Watch
for the rim brakes wearing and changing the "balance" in this system.
Another widely recommended setup (which again I've not tried) is to
connect the hub brake to a (spare) shift lever, under either rider's
control, since these auxiliary hub brakes are used so often as drag
brakes on long downhills. A bar-con on the stoker's bars might do this
dandy; I've been meaning to try it.
Mark "Wrote a FAQ on tandem disk brakes, many years ago" Janeba