what's so hard about getting a shifter and tightening the spokes? no
need for paying anyone money to do a monkeys job, and no spesh tools
needed... maybe just a bit more patience when using a shifter. my pos
ebay uni used to make a bad groan groan groan with each revolution and
all it took was a small shifter, some time, my fingers to squeeze each
spoke and test how much give it had and tighten as necessary... then
yes ofcourse spin the wheel and check it's alignment and adjust the
necessary spokes to bring the wheel back to center.
dude just get your uni, flip it over, and squeeze pairs of spokes with
your hand and see if they move. if they clearly do then there's atleast
A problem there, and as a few have said probably THE problem. takes
like 10 seconds to check them all and see if anythings funky or not!
DOO EEET!!!
--
nubcake
------------------------------------------------------------------------
nubcake's Profile: http://www.unicyclist.com/profile/15954
View this thread: http://www.unicyclist.com/thread/70264
Posted Via Usenet.com Premium Usenet Newsgroup Services
----------------------------------------------------------
http://www.usenet.com