Road Cycling · Public discussion

Re: Leather Saddle Repair?

Started by E. Willson · · Last activity · 1 post · 392 views

Thread details

What we know about this thread

Original section
Road Cycling
Published
22 October 2004
Last activity
22 October 2004
Original author
E. Willson
Posts
1
Discussion status
Public discussion
Total views
392
Views / 30 days
0

The navigation and discussion metadata provide context. Posts remain in their original chronological order.

Showing posts 1–1 of 1
Posts remain in their original chronological order.

Text size
  1. Take it to a good cobbler. Most likely he will be able to fix it.

    HTH,
    Ernie

    Steve Sr. said:

    My Lepper Voyager saddle has failed after only a little over 3 years
    and about 10K miles. The 3 rivets at the nose of the saddle have
    sheared off but the leather is still intact. The two outside (out of
    5) rivets at the rear of the saddle are also showing signs of
    corrosion. The saddle has been well maintained with proofhide and
    never exposed to rain.

    I suspect that the rivets were weakened by corrosion caused by
    perspiration and our humid summer weather. The rivets used were just
    brass plated steel and once the brass plating was gone the rivets just
    rusted until they were weak enough to shear off one by one.

    I also noticed that this saddle tended to stretch a lot on use and
    then tighten up once it dried out. I never tightened it while it was
    wet. It would almost stretch so much that it would contact the top of
    the seatpost. Is it supposed to stretch that much?

    Is this lifespan typical of a leather saddle. Do Brooks saddles hold
    up any better? I notice that they seem to be held together with much
    larger copper rivets.

    Thanks for your thoughts and suggestions.

    Steve

Active in the last 60 minutes

Active in this thread

0 users · 0 guests ·0 bots ·0 total

No signed-in users are active right now.

No known search crawlers active right now.