Does anyone else have problems with the newer PT 2.4 Wired CPU and an older version hub in that you have to continuously zero out the torque during a ride?
I can zero the torque before i start, and sure enough the watts will read low at some point in the ride, and when i go to zero the torque again it is reading -0.
This happened yesterday again on the trainer during FTP intervals. My second interval, even though i set the Computrainer at the same watts, were reading low, and according to my PE i could tell as well. Then i zero'd the torque and sure enough the third interval had an avg power of 10 watts higher (Computrainer watts were set the same for all 3 intervals).
I knew that it was a problem in the new 2.4 CPU when it went kaput and I had to send it back to Saris and borrowed an older version CPU (the same version that came with my SL PT) that worked flawlessly! I did not have to zero out the torque every day, even though i did, and it would not fluctuate like the new version. The torque remained stable throughout.
I have a teammate who has the same problem with the new PT2.4 wired CPU and older hub. I am wondering if there are more out there who have experienced this?