KH hub

yup, think so 🙄

--
giraffe

GizmoDuck said:

I yanked on my foot and straigtened it and stuck the bone back into
the skin.

🙄
------------------------------------------------------------------------
giraffe's Profile: http://www.unicyclist.com/profile/9372
View this thread: http://www.unicyclist.com/thread/47013

from what i recall, bearings belonging to the kh hub have a OD of 40mm,
the nimbus frame takes 42mm OD.
a shim should be able to sort this problem out.
also im not sure on the spcers required on the axel.
otherwise i think it should work

--
muzzle

sig.
------------------------------------------------------------------------
muzzle's Profile: http://www.unicyclist.com/profile/11458
View this thread: http://www.unicyclist.com/thread/47013

Thanks, I have a KH that I can measure bearing OD but not a Nimbus
trials. I have a Nimbus Muni., is that the same hub as the trials.
Thanks again

--
onebyone

Bill Blogs is an alien!
www.municycle.com.au
------------------------------------------------------------------------
onebyone's Profile: http://www.unicyclist.com/profile/10014
View this thread: http://www.unicyclist.com/thread/47013

The KH are 42mm OD

--
pdc

"What doesn't kill you strengthens you, what kills you strengthens your
mother"
------------------------------------------------------------------------
pdc's Profile: http://www.unicyclist.com/profile/8160
View this thread: http://www.unicyclist.com/thread/47013