INA bearing installation common problem solution

One of the installation surface and installation site requirement?
B: yes. If INA Parameter Of SKF 3307A-Z Bearing with iron filings, burr, dust and other foreign matter to enter, will make the bearing noise and vibration during operation, and even damage raceway and rolling body. So, before the installation of bearings, you
must ensure that the installation surface and the environment clean.
Second, bearing must be cleaned before installed?
INA bearing surface coated with anti-rust oil, you must use clean petrol or kerosene cleaning carefully, then coated with clean, high quality or high speed high temperature lubricating grease before installation. Cleanliness of bearing
life and the influence of vibration noise is very big. But we especially want to remind you is: fully enclosed bearing not clean fuel.
Three, how to select grease?
Lubrication of INA bearings work and life have very important influence, this to you a brief introduction to the general principles of the grease choice. Grease made out of base oil, thickener and additive, different types and different
type of same kind grease properties vary widely, allowing the rotation of the limit, when the choice is important to note. The performance of the grease is mainly composed of base oil, the basis of generally low viscosity oil is suitable
for low temperature, high speed, high viscosity is suitable for high temperature, high load. Thickener and relationship with lubrication performance, thickening agent, water resistance to the water resistance of the grease. In principle,
different brand of grease can't mix, and even the same thickening agent of grease, will also bring bad influence each other on the basis of different additives.