The spokes on my uni are really loose haha, and I know it is bad so I am not going to ride it until I get them tightened I know you can take them to a bike shop, but can you do it yourself?
-also I have a Torker DX if that would make a difference, which it shouldn't
You need a spoke wrench, you can buy one at any bike shop.
To tighten the spoke turn the wrench clockwise (if the spoke you are tightening is pointing towards you). Do this a little bit at a time going around the rim to keep tension even. If the rim is a bit too far to right tighten the spokes on the left and vice versa. Try to get an even tension on all the spokes. When you are doing your final tightening turn the wrench a bit past what you think would be right then back it off by that little bit again. This will prevent your spokes from being twisted when you are finished. You can check spoke tightness by plucking or hitting each spoke and listen to the pitch of the spoke; the higher the pitch, the tighter the spoke.
The first few times you do it it will probably be frustrating and take forever to get right but it gets easier with practice.
maybe some of the people on this website should buy skateboards as some of the questions i read are ridiculous........ go to the bike shop and ask them.