I was riding in the snow yesterday and I guess some got in the rear hub because there's grease on the outside. The wheel is only a couple weeks old. Should I regrease it or do you think it'll be ok? I don't think there was any salt where I was so I guess that's good.
In article <81MIf.63965$bF.39770@dukeread07>, Michael Shaffer
Quoted message said:
I was riding in the snow yesterday and I guess some got in the rear hub because there's grease on the outside. The wheel is only a couple weeks old. Should I regrease it or do you think it'll be ok? I don't think there was any salt where I was so I guess that's good.
Just a little excess lube working its way past the seals; wipe it off, no need for further lubicration.
The presence of snow is immaterial in this case - your hub's still shiny clean! The hub's seals prevents snow such as that in your photos (clean powder in temps below 0 Celsius) from working its way past the seals; it's the corrosive salty slush common on urban roads that's the most damaging, melting past seals and into interfaces.
I was riding in the snow yesterday and I guess some got in the rear hub because there's grease on the outside. The wheel is only a couple weeks old. Should I regrease it or do you think it'll be ok? I don't think there was any salt where I was so I guess that's good.
Hey, you should be rejoicing. What you see is a bit of excess grease working its way out past the seals. This is good news. It means whomever set-up your new wheel actually bothered to open and pack the bearings with some lube (most hubs with cups and cones have almost no lube in them when delivered from the factory). Nothing to worry about and no snow got in your hub; just wipe off the excess grease and go for another ride.
I was riding in the snow yesterday and I guess some got in the rear hub because there's grease on the outside. The wheel is only a couple weeks old. Should I regrease it or do you think it'll be ok? I don't think there was any salt where I was so I guess that's good.
Grease on the outside probably means it had a lot of grease in it-a good thing. You really can't put 'too much' grease into hubs, headsets or BBs(altho another Boulder local bike shop guy did say a HS wouldn't adjust 'cuz it had too much grease in it------where do these guys come from!!). Leave it there. It acts as a wonderful additional sealant to keep the nasty outside outside.