getting unicycle wet??

if you submerge the bearings a lot, or in dirty water, etc... they will
seize up. When the grease gets washed out by water, etc...that's not a
good thing.

Rinsing your uni off will do no damage, and is helpful for preventing
rust...if you have your uni out in salty roads in the winter, etc...

I never dry my uni's off after I wash them off...it's all good.

'You can take them apart and regrease them'
(http://www.londonunicyclingclub.ca/bearings.htm) , or you can buy new
ones.

Look at the picture of all the dirt and crud that comes out of the
bearings...that's bad.

--
Sofa - you - pee - dee

'Unicycle Product Reviews' (http://tinyurl.com/368h6) *107* reviews on
*72* products

'London Unicycling Club Website ' (http://www.brianmackenzie.com/LUC/)
version 3.02

------------------------------------------------------------------------
Sofa's Profile: http://www.unicyclist.com/profile/706
View this thread: http://www.unicyclist.com/thread/31930

Both my muni's bearings failed after riding thru only about 3 short
(10'-15'😉 and 1 long (50'😉 creak crossings. The muni has a KH wheelset,
the bearing had metal seals (I've replaced them with rubber sealed
bearings). The last muni ride included riding about 50' with the hub
submerged; the creaking was *quite* obnoxious by the end of the ride. I
suspect that just splashing or spraying the bearings is much less hard
on them than is submerging them (particularly, submerging them while
rotating).

After removing the bearings, one was so stiff I could not turn it by
hand at all; the other can still be turned by hand, but does not rotate
smoothly. I have not tried rebuilding them (yet) - I figure it's worth
giving that a try so I might get a "free" spare set of useable bearings.
-- Thanks for that link, Sofa.

--
duaner - -

duaner.
------------------------------------------------------------------------
duaner's Profile: http://www.unicyclist.com/profile/4297
View this thread: http://www.unicyclist.com/thread/31930