CyclingForums
A community for cyclists, gear, training and racing.
Mountain Bikes · Public discussion
This thread is locked and is currently read-only.
Thread details
The navigation and discussion metadata provide context. Posts remain in their original chronological order.
looking for some advide on fork removal. Fork in question is a 1999 judy xc.
All instructions say the same thing: "loosen shaft bolt a few turns, and tap with a mallet. shafts will magically come free from lower tubes."
The problem is, that I tapped. Then I tapped more firmly. Now I have worked up to pounding, all with no success, and i have yet to see a single drop of oil come from the bottom of the shaft.
Any thoughts other than "tapping" to free the lower shafts? Thanks in advance.
It's been years since I've overhauled a Judy...but if memory serves you have to 1st remove the top cap which with let you compress the fork all the way...then back the screw out, and tap with a mallot....It should just pop free
Active in the last 60 minutes
0 users · 0 guests ·0 bots ·0 total
No signed-in users are active right now.
No known search crawlers active right now.