EGG BEATERS

"Andrew" <[email hidden]> wrote in message "]news:[email hidden]...

Quoted message said:

Hey crank bros riders out there, i need your expertise here

How can i know if my beaters need to be rebuilt, Im getting an annoying creackfest when pounding
on them but cannot say if it comes from the bb or the pedals, cranks are tight, pedals feel normal
but there's something rotten down there. any ideas.

Pop the rubber dust cap out of the end and remove the allen head cap screw. The body will slide off
of a spindle. Clean the parts with WD40, or whatever, grease the spindle and re-install. CB has a
$15 rebuild kit.

crankbrothers.comcrankbrothers.comOpen ↗

--
DTW .../\.../\.../\...

I've spent most of my money on mountainbiking and windsurfing. The rest I've just wasted.

Isolate each component.

Spin the pedals and if they feel at all rough or notchy, chances are they need some lovin'. Also
check to see if they are at all loose. It's also a good idea to make sure they are seated intot he
crank, and have plenty of grease on the threads.

Remove the chain from the front rings and spin the bb. again check for roughness, notchiness or side
to side play.

Give the frame look see too. I had a persistent creak on my XLM that turned out to be a crack in the
weld above the bottom bracket.

A

Andrew said:

Hey crank bros riders out there, i need your expertise here

How can i know if my beaters need to be rebuilt, Im getting an annoying creackfest when pounding on
them but cannot say if it comes from the bb or the pedals, cranks are tight, pedals feel normal but
there's something rotten down there. any ideas.

Andrew <[email hidden]> wrote in message "]news:[email hidden]...

Quoted message said:

Hey crank bros riders out there, i need your expertise here

How can i know if my beaters need to be rebuilt, Im getting an annoying creackfest when pounding
on them but cannot say if it comes from the bb or the pedals, cranks are tight, pedals feel normal
but there's something rotten down there. any ideas.

just buy the ne w look version built under licence by look with cartridge bearings.

David Bailey said:

Andrew <[email hidden]> wrote in message "]news:[email hidden]...

Quoted message said:

Hey crank bros riders out there, i need your expertise here

How can i know if my beaters need to be rebuilt, Im getting an annoying creackfest when pounding
on them but cannot say if it comes from the bb or the pedals, cranks are tight, pedals feel normal
but there's something rotten down there. any ideas.

just buy the ne w look version built under licence by look with cartridge bearings.

Yea, wish that I'd have known this 3 months ago when I bought mine. There's already slop in the
nylon sleeve -- I can rock the pedals up and down. But, they don't seem to be taking on water or
grit so I haven't replaced the bearings yet.

I hate to throw something that expensive to the side and replace it with something even more
expensive when it's still working, but I may do just that if I'm going to be replacing bearings
every 3 or 4 months <sigh>.

David