I lost my manual for my cat-eye micro computer (cc-6000) and the cat-eye home page did not have this manual. Does anyone have a copy they could e-mail. When I put in a new battery there are vertical lines on the bottom of the screen bu the buttons do not respond. Thx.
-----= Posted via Newsfeeds.Com, Uncensored Usenet News =----- newsfeeds.comnewsfeeds.comOpen ↗ - The #1 Newsgroup Service in the World! -----== Over 80,000 Newsgroups - 16 Different Servers! =-----
I lost my manual for my cat-eye micro computer (cc-6000) and the cat-eye home page did not have this manual. Does anyone have a copy they could e-mail. When I put in a new battery there are vertical lines on the bottom of the screen bu the buttons do not respond. Thx.
Remove the battery, short out the contacts for about a minute and depress the reset button on the back as well as the two front buttons. This will drain any residual power from the unit that might keep it from properly resetting. (To short out the contacts, you can just put the battery in upside-down).
Now put the battery back in, and, once again, hold down all three buttons until the computer completely resets. It will probably be OK after that.
"howard" <[email hidden]> wrote in message "]news:[email hidden]...
Quoted message said:
I lost my manual for my cat-eye micro computer (cc-6000) and the cat-eye home page did not have this manual. Does anyone have a copy they could e-mail. When I put in a new battery there are vertical lines on the bottom of the screen bu the buttons do not respond. Thx.
Try either a new install of the battery, being careful not to wiggle it on the way in - just a smooth positive connection - or press all the buttons at the same time to re-initailize the unit. These are sensitive to intermittent battery contact on installation.
I lost my manual for my cat-eye micro computer (cc-6000) and the cat-eye home page did not have this manual. Does anyone have a copy they could e-mail. When I put in a new battery there are vertical lines on the bottom of the screen bu the buttons do not respond. Thx.
When installing a new battery in a CC-6000, you should perform a reset by pressing all three buttons simutaneously. This should clear the display.
BTW, I have a couple of these manuals, but not in a machine readable form. If you have a specific question, just email.