Hi Folks -
I recently received a new frame and fork with headset installed.
I stipulated a Campy Chorus (threaded) headset, not their usual "what
they have laying around".
It's a canti brake model, so they also included a nice looking cable
hanger. Two questions.
1.) I noticed the hanger has a habit of turning out of relationship
with the fork. It has a key that is small and doesn't seem to stay in
the keyway of the fork. It also has one washer with key installed
above and next to the adjusting cone. I'm wondering if there should
be another washer with key above the cable hanger or ??? to prevent
the hanger from turning out of sync.
2.) I also noticed there is a space between the upper cup and the
adjusting cone. In all the photos and illustrations of assembled
headsets I find a space much smaller than that on my bike. In fact I
can look into this opening and almost see the bearings. The upper
adjusting cone's outer lip does not extend below the cups rim. If I
remove the bearings, this slides easily together. Are the upper and
lower bearings/retainers different on this model?
Thanks for any help you might offer. Perhaps a web link to any
instructional material might assist.
Phil B