Brooks B67

Richard said:

Just got a B67. My seatpost is, I think, a "microadjust" - clamps two
rails between two plates, which can rotate against a serrated edge.
Similar to this:
http://www.rutlandcycling.com/productimages/fullsize/next%20seatpost.jpg

So, my question is, is this suitable for the B67? Do I just clamp it
round the lower rails as with my current saddle?

The B67 should only have a single set of rails, and they should fit in a
micro-adjust no problem. If you've got 2 pairs of rails you've got a
B66 which needs a separate clamp and a plain seatpost.

Pete.
--
Peter Clinch Medical Physics IT Officer
Tel 44 1382 660111 ext. 33637 Univ. of Dundee, Ninewells Hospital
Fax 44 1382 640177 Dundee DD1 9SY Scotland UK
net [email hidden] http://www.dundee.ac.uk/~pjclinch/

Peter Clinch said:

The B67 should only have a single set of rails, and they should fit in a
micro-adjust no problem. If you've got 2 pairs of rails you've got a
B66 which needs a separate clamp and a plain seatpost.

Pete.

or a sandwich (www.m-gineering.nl/twinrail.jpg) and a longer bolt

--
---
Marten Gerritsen

INFOapestaartjeM-GINEERINGpuntNL
www.m-gineering.nl

M-gineering said:

Peter Clinch said:

The B67 should only have a single set of rails, and they should fit
in a micro-adjust no problem. If you've got 2 pairs of rails you've
got a B66 which needs a separate clamp and a plain seatpost.

or a sandwich (www.m-gineering.nl/twinrail.jpg) and a longer bolt

St John Street Cycles had these last time I looked.

~PB