Is it possible (and practically feasible) to add a 3rd, small, chainring to a Giant TCR 2? It has
only two, and it is hard going uphill.
Thanks very much!
A community for cyclists, gear, training and racing.
Cycling Equipment · Public discussion
Thread details
The navigation and discussion metadata provide context. Posts remain in their original chronological order.
Is it possible (and practically feasible) to add a 3rd, small, chainring to a Giant TCR 2? It has
only two, and it is hard going uphill.
Thanks very much!
"florin" <[email hidden]> wrote in message "]news:[email hidden]...
Quoted message said:Is it possible (and practically feasible) to add a 3rd, small, chainring to a Giant TCR 2? It has
only two, and it is hard going uphill.Thanks very much!
You would have to change the crankset and bottom bracket, at least. Perhaps a better way, not
including getting in better condition yourself, is if you are using Shimano equipment have an XT
rear derailluer and cassette installed. This is much less expensive, easier to do, and you can
change your gearing back to its original configuration fairly easily.
In article said:Is it possible (and practically feasible) to add a 3rd, small, chainring to a Giant TCR 2? It has
only two, and it is hard going uphill.
Yes, what you do is replace the crankset, bottom bracket, and front derailleur, often the rear
derailleur as well, sometimes the chain.
One cheaper alternative is to replace only the cassette cogs - if you have a bike equipped with a
short-cage Shimano rear derailleur then you should be able to install a 12-27 cogset which might be
a little lower than you have.
Or you can also replace the cassette cogs and the rear derailleur, going to a mountain bike
derailleur such as Deore LX, and installing a wide-range MTB cassette such as a 11-32. New chain
also required for that, but don't have to replace cranks or front derailleur, very easy conversion.
Depending on which crankset you have, you may also be able to replace your 39-tooth small
chainring with a 38. Doesn't work on all 130mm BCD crank arms though as the spider sticks up too
far on some of them.
--Paul
rinflo-<< Is it possible (and practically feasible) to add a 3rd, small, chainring to a Giant TCR 2?
It has only two, and it is hard going uphill.
Possible but not considering a 'tripleizer', you will need a triple crank, longer bottom bracket,
new front der and maybe rear and perhaps also a triple compatible left shifter-lots of bucks OR
If shimano, get a MTB rear der, like a XT, and a MTB cogset, like a 12-32 or so-
Peter Chisholm Vecchio's Bicicletteria 1833 Pearl St. Boulder, CO, 80302
(303)440-3535 vecchios.comvecchios.comOpen ↗ "Ruote convenzionali costruite eccezionalmente bene"
(florin) said:Is it possible (and practically feasible) to add a 3rd, small, chainring to a Giant TCR 2? It has
only two, and it is hard going uphill.Thanks very much!
How long have you been riding?
--
Scott Johnson "Always with the excuses for small legs. People like you are why they only open the
top half of caskets." -Tommy Bowen
Active in the last 60 minutes
0 users · 0 guests ·0 bots ·0 total
No signed-in users are active right now.
No known search crawlers active right now.